MAJOR COMPONENT LOCATION
BEFORE STARTING
FUEL VALVE
CHOKE LEVER
ENGINE KILL SWITCH
IGNITION KEY SWITCH
The two-way fuel valve is used to control the flow of
fuel to the engine. The valve is located on the left side
under the fuel tank. Turing the lever to the ON position
allows fuel to flow to the carburetor and turning it to
the OFF position stops the flow. Always keep the fuel
valve in the OFF position when not using the dirt bike.
Before starting your MVx70, be sure these four components are in the RUN position:
1. Fuel Valve 2. Choke Lever 3. Engine Kill Switch 4. Ignition Key Switch
The location and operating information for each of these controls is shown below:
The choke lever is used to start the engine when it is
cold and is located on the left side of the carburetor. It
is used to restrict the amount of air in the fuel mixture
to start easier and warm up. Flip the lever up to the
FULL position to start, and then as the engine warms
up move the lever down to the OFF position.
The engine kill switch is located next to the left hand
grip on the handlebars. The kill switch must be in the
START/RUN position for the engine to start. To stop the
engine, flip the button down to the STOP position.
The Ignition Key Switch is used to start the engine
and is located on the left side of the dirt bike, under
the fuel tank. Before attempting to start the engine,
be sure the key is in the START/RUN position which is
indicated by a red dot. When finished riding switch the
key to the OFF position, indicated by a blue dot.
OPERATING CONTROLS
OPERATING CONTROLS
9
8
OPERATING CONTROLS
Kick Starter
Spark Plug
Rear Brake Pedal
Oil Fill & Dipstick
Fuel Valve
Key Ignition Switch
Fuel Cap & Vent
Air Filter
Gear Shifter
Kick Stand
Drive Chain
Choke Lever
Fuel Valve
Choke Lever
Engine Kill Switch
Ignition Key Switch
TROUBLE
?
DO NOT RETURN TO STORE
contact us!
888-488-MOTO (6686)
or email [email protected]
Summary of Contents for MVX70
Page 26: ......
