FRONT BRAKE LEVER
KICKSTARTER
THROTTLE
AIR FILTER
SHIFT LEVER
SPARK PLUG
REAR BRAKE PEDAL
Kick Stand
The Front Brake Lever is used to apply braking to the
front wheel. When you pull the lever back, braking
power is applied to the front wheel. The harder it
is pulled, the more braking power is applied to the
wheel. To release the front brake, release the front
brake lever.
The kickstarter is used to start the engine and is
located on the right side of the engine behind the
right foot peg. To use the kickstarter flip it outward
from its stored position, hold the bike firmly while
straddling the bike. Place your right foot on the
kickstarter and push down quickly. The kickstarter
will return to its stored position when released.
When operating your MVx70 there are several key operating controls that allow you
to operate your dirt bike. Their location and operation information is shown below.
1. Front Brake Lever 2. Throttle 3. Shift Lever 4. Rear Brake Pedal
When operating your MVx70 there are several key operating controls and components
that allow you to operate your dirt bike and perform routine maintenance.
Their location and operation information is shown below.
1. Kick Starter 2. Air Filter 3. Spark Plug 4. Kick Stand
The Throttle controls the speed of the engine and is
located in the right grip on the handlebars. To increase
the engine speed, twist the throttle grip toward you,
or downward. To decrease the engine speed, twist
the grip away from you, or upward. The throttle grip is
spring loaded so it will return to the lowest position as
you release it.
The air filter is used to keep dirt and debris out of the
carburetor air supply. Examine the air filter before each
ride to be sure that it is not clogged with dirt and dust
to keep your dirt bike running well. The air filter can be
removed and tapped gently on a hard surface to clean
out most of the dust. Replace the air filter periodically.
The Shift Lever is used to change the gears and is
located ahead of the left foot peg. To select the next
higher gear, pull up until it clicks. To select the next
lower one, push down until it clicks. The MVx70 is
equipped with four gears and does not use a clutch.
Let off on the throttle when shifting.
The spark plug is used to provide spark to the engine
to make it run. You should never touch the spark plug
when the engine is running as you could be shocked.
The spark plug will become worn or plugged after
many hours of operation. Refer to the servicing section
of this manual for cleaning/replacing instructions.
The Rear Brake Pedal is used to apply braking to the
rear wheel and is located ahead of the right foot peg.
When you push the pedal down, braking power is
applied to the rear wheel. The harder it is pushed, the
more braking power is applied to the wheel. To release
the rear brake, release the rear brake pedal.
The Kickstand is used to support the dirt bike when
it is parked and is located on the left side of the bike
below the left foot peg. To operate it, use your foot to
swing the kickstand to its downward position and lean
the bike onto it. Be sure to raise the kickstand up when
riding or serious injury can result.
OPERATING CONTROLS
OPERATING CONTROLS
11
10
OPERATING CONTROLS
Front Brake Lever
Kickstarter
Throttle
Air Filter
Shift Lever
Spark Plug
Rear
Brake Pedal
Kickstand
TROUBLE
?
DO NOT RETURN TO STORE
contact us!
888-488-MOTO (6686)
or email [email protected]
Summary of Contents for MVX70
Page 26: ......