Motorola XT660d, User Manual

Page: 62 / 90

6 Place the Source radio in the SUC. Press and
release the
SB1 button.
7 When the cloning is completed, the Source radio
audible voice will announce either “successful” or
“fail”. If the Source radio is a display model radio, it
will either show
Pass
or
Fail
on the display (a tone
will be heard within 5 seconds).
8 Once the cloning process is completed, turn the
radios off and on again to exit “Clone” mode.
5.5
What To Do If Cloning Fails
The radio audible voice will announce “Fail” indicating that
the cloning process has failed. In the event that the cloning
fails, perform each of the following steps before attempting
to start cloning process again:
1 Ensure that the batteries on both radios are fully
charged.
2 Check the cloning cable connection on both SUCs.
3 Ensure that the battery is engaged properly on the
radio.
4 Ensure that there is no debris in the charging tray or
on the radio contacts.
5 Ensure that the Target radio is turned on.
6 Ensure that the Source radio is in cloning mode.
7 Ensure that the two radios are both from the same
frequency band, same region and have the same
transmission power.
NOTICE:
This cloning cable is designed to operate only
with compatible Motorola Solutions SUC
RLN6175 and PMLN6394.
When ordering Cloning Cable, please refer to P/N#
HKKN4028_. See
Accessories on page 87 for more
information about the accessories.
English
62
Send Feedback