Motorola XR400, Integration Manual

Page: 37 / 126

Administrator Console 3 - 9
5.
In the Gain: drop-down list select the gain (a percentage) to designate the antenna power setting for reading
RFID tags.
6.
Enter how many times to repeat the read command when performing a scan in the Retry: text box.
7.
The Air Protocol, is pre-set to: Gen2 (see Table 1-1 on page 1-2 for model read settings).
8.
Select a filter from the Tag Selection: drop-down list to specify which tags to read. See Query Tags on page
3-12 for information on creating filters.
9.
In the Write Gain: drop-down list select the gain (a percentage) to designate the antenna power setting for
writing RFID tags.
10.
Check the Enable Antenna Check check box to check for presence of a Motorola antenna. To disable the
antenna check, do not check the Enable Antenna Check check box.
1.
Click Add Class . The new class appears in the Class List .
2.
If the motion detectors are enabled (see Configuring Reader Properties on page 3-28 ) select which motion
detectors, if any, are used from the Motion: drop-down list.
3.
Click Commit / Revert . See Committing / Discarding Changes on page 3-40 .
4.
Click Configuration . The Reader Configuration window displays a list of antennas (read points).
XR400/440/450 provides up to four read points and XR480 provides up to eight read points.
Figure 3-9
XR400 Read Point Selection
When Antenna Check is disabled, the reader will not check for a physical antenna connection. With Antenna
Check disabled, the reader reports the corresponding antenna port status as connected regardless the antenna
connection status.