Motorola SYMBOL DS6707, Product Reference Manual

Page: 47 / 424

Maintenance & Technical Specifications 3 - 3
Digital imager scanner decodes bar
code, but does not transmit the data to
the host. Digital imager scanner is not
programmed for the correct host type. Scan the appropriate host type
programming bar code. See the chapter
corresponding to the host type.
Interface cable is loose. Re-connect the cable.
If 4 long low beeps are heard, a
transmission error occurred. Set the digital imager scanner's
communication parameters to match the
host's setting.
If 5 low beeps are heard, a conversion
or format error occurred. Configure the digital imager scanner's
conversion parameters properly.
If low/high/low beeps sound, an invalid
ADF rule is detected. Program the correct ADF rules.
If high/low beeps sound, the digital
imager scanner is buffering Code 39
data. Normal scanning a Code 39 bar code and
the Code 39 Buffering option is enabled.
Host displays scanned data
incorrectly. Digital imager scanner is not
programmed to work with the host. Scan the appropriate host type
programming bar code.
For RS-232, set the digital imager
scanner's communication parameters to
match the host's settings.
Program the proper editing options (e.g.,
UPC-E to UPC-A Conversion).
Digital imager scanner emits
high/high/high/low beeps when not in
use. RS-232 receive error. Normal during host reset. Otherwise, set
the digital imager scanner's RS-232 parity
to match the host setting.
Digital imager scanner emits low/high
beeps during programming. Input error or Cancel bar code was
scanned. Scan the correct numeric bar codes
within range for the parameter
programmed.
Digital imager scanner emits
low/high/low/high beeps during
programming. Out of ADF parameter storage space. Erase all rules and re-program with
shorter rules.
Digital imager scanner emits
low/high/low beeps. Clearing Code 39 buffer. Normal when scanning the Code 39
Buffering Clear Buffer bar code or upon
attempt to transmit an empty Code 39
buffer.
Digital imager scanner emits a
power-up beep after changing USB
host type. The USB bus re-established power to
the digital imager scanner. Normal when changing USB host type.
Digital imager scanner emits one high
beep when not in use. In RS-232 mode, a <BEL> character
was received and Beep on <BEL>
option is enabled. Normal when Beep on <BEL> is enabled
and the digital imager scanner is in
RS-232 mode.
Table 3-1
Troubleshooting (Continued)
Problem Possible Causes Possible Solutions