Motorola SYMBOL DS6707, Product Reference Manual

Page: 27 / 424

Getting Started 1 - 5
Removing the Interface Cable for Scanner with Base
1.
Turn both angle adjustment knobs left to loosen the scanner in the base. See Figure 1-5 .
2.
Move the scanner forward until there is full access to the cable interface port on the bottom of the scanner.
3.
Using the tip of a screwdriver, depress the cable’s modular connector clip. See Figure 1-4 .
4.
Carefully slide out the cable.
5.
Follow the steps for Installing the Interface Cable to connect a new cable.
6.
Move the scanner to preferred angle and turn the angle adjustment knobs right to tighten.
Configuring the Digital Imager Scanner
To configure the digital imager scanner, use the bar codes in this manual, or the 123Scan
2
configuration program.
See Chapter 4, User Preferences & Miscellaneous Digital Imager Scanner Options and Chapter 6, Imaging
Preferences for information about programming the digital imager scanner using bar code menus. Also see each
host-specific chapter to set up connection to a specific host type.
1.
See Chapter 9, 123Scan2 to configure the digital imager scanner using this configuration program. The
program includes a help file.
Mounting the Digital Imager Scanner
Desk Mount
Use the optional desk mount for convenient and protective placement of the digital imager scanner on a flat
surface. Simply place the mount on the surface. The rubber feet hold the mount securely in place when inserting
and removing the digital imager scanner.
Figure 1-6
Inserting the Digital Imager Scanner in the Desk Mount
Alternatively, secure the desk mount to a desk surface by inserting two screws* appropriate for the mounting
surface through the screw holes of the desk mount, and into the surface. Screw the desk mount onto the surface
with or without the rubber feet.
*The recommended screws are two #6 screws (5/8” long).