Installation
31
GPS Connection
The MW810 Mobile Workstation may be supplied with an optional internal module of
Global Positioning System (GPS). Connect the cable connector of the GPS antenna to the
GPS connector at the rear panel of the CPU Box, on one side, and to the connector of an
active GPS antenna on the other side.
To install the GPS antenna to the vehicle, refer to the installation instructions of the antenna
manufacturer.
Recommended antenna: PCTEL, 35dB stud mount antenna with jam nut. Motorola part
number 8508851K66.
Video In Connection
Standard Composite CVBS video input. The MW810 Mobile Workstation is equipped with a
BNC type connector to which a video camera can be connected. A BNC to RCA adapter (P/
N 5802810C07) is also available from Motorola.
Important Note:
the Video In input is only supported in the “Comm & Video I/O
Expansion Board” CPU Box option.
USB Connections
The MW810 Mobile Workstation is equipped with standard Universal Serial Bus (USB) type
A receptacles. The CPU Box USB connection is for general purpose USB 2.0 devices, and
the display USB receptacles are for connecting a QWERTY style keyboard and any USB
device.
USB devices are hot-pluggable. This means you can connect and disconnect devices while
your operating system is running. Using USB ports you can connect external low, high, and
full-speed USB devices. The USB ports support maximum transfer rate of 480 MB/s.
When a SBR-LS GPS Module is used, dead reckoning intelligence can
be achieved only if vehicle speed (SPEED+ and SPEED-) and
direction (FWD+, FWD-) inputs are connected to the auxiliary port of
the CPU Box. For details see “AUX Port Connection” on page 35.
Note
• Do not use the right or left-side USB ports of the display for permanent
connections. Always disconnect USB accessories from these ports when
driving.
• A device connected to the USB port should not consume more than 0.5A.
Otherwise, the system will not operate properly.
• Be aware USB devices connected to the USB port should be compliant with the
operating system. Otherwise the system will not operate properly.
• To keep the display unit sealed, use the rubber plugs attached to the display to
cover the USB ports.
!
Caution
Summary of Contents for MW810
