Configure and Environment Commands
A-8
Installation Guide
A
Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options
Default
Meaning of Default
Memory Size Ending Address
Base Address of Local Memory
Size of Local Memory
02000000
00000000
02000000
The default ending
address is the calculated
size of local memory.
The beginning address
of Local Memory. It
must be a multiple of
the Local Memory board
size, starting with 0. The
Bug will set up the
hardware address
decoders so that the
Local Memory resides
as one contiguous block
at this address. Default
is $0.
The default is the
calculated size of the
local memory.
Slave address decoders setup. The slave address decoders are use to allow another VMEbus
master to access a local resource of the MVME197LE. There are two slave address decoders
set. They are set up as follows.
Slave Enable #1 [Y/N]
Slave Starting Address #1
Slave Ending Address #1
Y
00000000
01FFFFFF
Setup and Enable the
Slave Address Decoder
#1.
Base address of the local
resource that is
accessible by the
VMEbus. Default is the
base of local memory,
$0.
Ending address of the
local resource that is
accessible by the
VMEbus. Default is the
end of calculated
memory.
Solution Systems Technologies Inc.
720-565-5995 | [email protected] | www.solusys.com
Solution Systems Technologies Inc.
720-565-5995 | [email protected] | www.solusys.com
