Motorola MVME1603, Installation And Use Manual

Page: 54 / 222

MVME760 Transition Module Installation
1-40
1
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
!
Caution
Inserting or removing modules with power applied may result
in damage to module components.
!
Warning
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
3. Remove the filler panel(s) from the appropriate card slot(s) at the
front or rear of the chassis. (You may need to shift other modules in
the chassis to allow space for the cables connected to the
MVME760 transition module.)
4. Attach the flat ribbon cable supplied with the MVME760 to the P2
backplane connector at the slot occupied by the MVME1600-001
base board. Route the cable to P2 on the transition module. Be sure
to orient cable pin 1 with connector pin 1.
!
Caution
Avoid touching areas of integrated circuitry; static discharge
can damage these circuits
5. Secure the MVME760 in the chassis with the screws provided,
making good contact with the transverse mounting rails to minimize
RF emissions.
6. Replace the chassis or system cover(s), making sure no cables are
pinched. Cable the peripherals to the panel connectors, reconnect
the system to the AC or DC power source, and turn the equipment
power on.