Hardware Preparation and Installation
1-21
1
To complete the configuration of the clock lines, you must also set serial
port 4 clock configuration header J15 on the MVME712M transition
module (described later in this chapter). For details on the configuration of
that header, refer to the MVME712M Transition Module section or to the
user’s manual for the MVME712M (part number MVME712M).
Serial Port 4 I/O Path Selection (J9)
On the MVME1600-011, serial port 4’s I/O signals are routed to backplane
connector P2 and to front panel connector J3. Header J9 determines the
state of the DSR, RI, and TM signals on serial port 4.
With a jumper installed on J9, DSR, RI, and TM come from the front
panel.
With the jumper removed, P2 I/O is selected. The DSR, RI, and TM signals
are not supported in this case, so DSR is held true while RI and TM are
held false.
Jumper On = Front Panel I/O
DSR, RI, and TM from front panel
to 8536 device
Jumper Off = P2 I/O (factory configuration)
DSR to 8536 device held true
RI and TM to 8536 device held false
J9
J9
2
1
2
1
Summary of Contents for MVME1603
