ENV - Set Environment
6-4
6
Remote Start Method Switch [G/M/B/N] = B?
The Remote Start Method Switch is used when the
MVME1603/MVME1604 is cross-loaded from another VME-based
CPU, to start execution of the cross-loaded program.
Probe System for Supported I/O Controllers [Y/N] = Y?
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Network PReP-Boot Mode Enable [Y/N] = Y?
G
Use the Global Control and Status Register (GCSR,
located in the VMEchip2 on PowerPC board series
modules) to pass and start execution of the cross-
loaded program.
M
Use the Multiprocessor Control Register (MPCR) in
shared RAM to pass and start execution of the cross-
loaded program.
B
Use both the GCSR and the MPCR methods to pass
and start execution of the cross-loaded program.
(Default)
N
Do not use any Remote Start Method.
Y
Accesses will be made to the appropriate system
buses (e.g., VMEbus, local MPU bus) to determine
the presence of supported controllers. (Default)
N
Accesses will not be made to the VMEbus to
determine the presence of supported controllers.
Y
NVRAM (PReP partition) header space will be
initialized automatically during board initialization.
(Default)
N
NVRAM header space will not be initialized
automatically during board initialization.
Y
Enable PReP-style network booting (same boot image
from a network interface as from a mass storage
device). (Default)
N
Do not enable PReP-style network booting.
Summary of Contents for MVME1603
