Motorola MTM800 FuG ET, Basic Service Manual

Page: 65 / 120

Maintenance 6 - 9
Figure 6-5 Diecast Cover Removal
3. Remove the two connector clips on the antenna connector and power connector. A tool can
be used to remove the clips, if required.
4. Remove the GPS cable connector from the transceiver board.
5. Open the dust cover situated on the left side of the terminal. If a SIM card is present, push it to
dislodge and remove the SIM card.
Figure 6-6 Open Dust Cover
6. Pull out the plastic accessory connector housing from the back of the terminal.
NOTE:
The diecast cover may be difficult to remove due to the main seal adhesion, if the
diecast cover has not been removed for a long time. The dismantling tool (Motorola
part number 6686119B01) can be used as a lever to pry and remove the diecast
cover.
CAUTION: Do NOT disconnect the GPS cable connector by jerking or pulling the cable;
instead disconnect by pulling the connector-head from the transceiver board.
NOTE:
The SIM card must be removed before the transceiver board is removed to prevent
damage to the SIM card and connector.
CAUTION: Do NOT use excessive force or twist the plastic accessory connector housing, as
this may damage the connector pins.
Diecast
Cover
Terminal
Chassis
Screws (7x)
!
!