Motorola MTM800 FuG ET, Basic Service Manual

Page: 43 / 120

Test Setup & Testing for 380–430 MHz 5.1 - 5
4. Configure the parameters for the “System ID and Access Parameters”.
a. Press the “Config” soft key twice, then go to “Configure”, followed by “System ID
& Access Parameters”, and press the “Select” soft key.
b. Enter the parameters outlined below:
Mobile Country Code (MCC): 234
Mobile Network Code (MNC): 2392
Base Station Color Code (BCC): 1
Location Area Code (LA): 224
5. Configure the parameters for the “Mobile Parameters”.
a. Press the “Config” soft key twice, then go to “Configure”, followed by “Mobile
Parameters”, and press the “Select” soft key.
b. Enter the parameters outlined below:
Short Subscriber Identity (SSI): (use fixed) 100
Group Short Subscriber Identity (GSSI): (use fixed) 3001
Power Class: (use fixed) 3 (40.0dBm / 10W)
Receiver Class: (use fixed) B
Note: The number for Short Subscriber Identity (SSI) and Group Short Subscriber
Identity (GSSI) base on the number key in the Codeplug of the radio.
6. Configure the parameters for the “Call Types”.
a. Press the “Config” soft key twice, then go to “Configure”, followed by “Call
Types”, and press the “Select” soft key.
b. Enter the parameters outlined below:
Priority: 00 = Priority Not Defined
Calling Party SSI: 100
7. Configure the parameters for the “Call Timers and Trunking”.
a. Press the “Config” soft key twice, then go to “Configure”, followed by “Call Timers
& Trunking”, and press the “Select” soft key.
b. Enter the parameters outlined below:
Trunking Type: Transmission
Simplex Traffic Channel Type: DL and UL TCH
Test Set Transmit Mode: Continuous
c. Leave the rest of the parameters in their default values.
8. Configure the parameters for the “Neighbor Cell Info”.
a. Press the “Config” soft key twice, then go to “Configure”, followed by “Neighbor
Cell Info”, and press the “Select” soft key.