Motorola MOTOWI 4, User Manual

Page: 111 / 198

Web Page Reference
111
8.3.10 Remote Management Page
The Remote Management page (
Figure 68
) allows the system administrator to configure the
remote management of the PTP 500 Series Bridge.
8.3.10.1 Control Access to HTTP Interface
The attribute
HTTP Access Enabled
allows a user to stop any access to a unit via the web
interface. The default value for this control is set to “yes”, which means that the unit can be
accessed using the web interface. If the option “No” is selected, then a warning is displayed as
shown in
Figure 69 .
8.3.10.2 Control Access to Telnet Interface
The attribute HTTP Telnet Enabled allows a user to stop any access to a unit via the telnet
interface. The default value for this control is set to “yes”, which means that the unit can be
accessed using the telnet interface
20
8.3.10.3 SNMP (Simple Network Management Protocol)
The industry standard remote management technique is SNMP (Simple Network Management
Protocol). The PTP 500 Series Bridge supports version 1 and version 2c of the SNMP protocol.
8.3.10.4 Supported Management Information Bases (MIBS)
The PTP 500 Series Bridge SNMP stack currently supports the following MIBs:
•
MIB-II, RFC-1213, The PTP 500 Series Bridge supports the ‘System Group’ and ‘Interfaces
Group’.
•
Bridge MIB, RFC-1493, The PTP 500 Series Bridge supports the ‘dot1dBase Group’ and the
‘dot1dBasePortTable Group’.
•
PTP 500 Series Bridge proprietary MIB
•
RFC-2233 (High capacity counter) MIB
•
WiMAX MIB SNMP TRAPs supported:
•
Cold Start
•
Link Up
•
Link Down
•
DFS Channel Change
•
DFS Impulsive Interference
Note that if HTTP, Telnet and SNMP interfaces have been disabled, then the user needs to use the Recovery image
20
to Şreset IP & Ethernet Configuration back to factory defaultsŤ to re-enable the HTTP-Telnet interfaces. SNMP
can also be used to re-enable the other interfaces if SNMP is enabled.