Motorola DSR-4550, Operator'S Manual, Page: 41 / 98

DSR-4550 31
Operating the DSR-4550
Press any arrow button (
4
) to back out of the field and leave it unchanged.
Otherwise, press the ENTER button to proceed. The following message displays
.
Core Menu
The Core menu allows the user to change the front panel Liquid Crystal Display
(LCD) contrast, select where text (e.g., subtitles) is displayed, and turn on/off the
LNB power output to Port 1.
Press the

buttons until the Core menu appears (shown below).
Contrast Field Default: 18
To adjust the LCD contrast, press the
4
button until the cursor is at the Contrast
label, and press the ENTER button to move into the field. Use the arrow buttons
(
4
) to select a value between 1 and 30, with 1 representing the least
contrast and 30 the most. Adjust the contrast so that the LCD panel can be read
clearly. Press the ENTER button to confirm the selection.
TSID Field Default: 0000
Note: The Transport Stream ID (TSID) field is not supported at this time.
The TSID field (range 0000 to FFFF) is a hexadecimal number to identify the
Transport Stream. The TSID value applies when the symbol rate is 4.88 Msps or
less, then the unit uses this value during manual tune to acquire the correct signal.
Press E to continue or to stop
Power Cycle reset in progress. . .
E 18
 Core  Contrast  TSID(hex)
Not
Supported