Motorola CPV5000, Installation And Reference Manual

Page: 83 / 144

Removing and Replacing the Battery
5-3
5
Installing DRAM SIMMs
To install SIMMs, locate the memory banks on the single board computer.
Before installing SIMMs, remove power from the system and disconnect all
power cords. After power has been removed, remove the CPV5000 from the
chassis.
!
Caution
Only qualified, experienced electronics personnel should access the
interior of a chassis. The components of the CPV5000 are sensitive to
static discharge. While out of the chassis, components should be
placed on a static-dissipative surface or into a static-shielding bag.
Installation instructions
No tools are required for this procedure.
1. Remove power from the chassis and disconnect all power cords.
Remove the CPV5000 from the chassis.
2. Locate the SIMM slots on the CPV5000.
Hold the SIMM so the notched edge is aligned with the notch on the
SIMM socket.
3. Insert the SIMM at a 45 degree angle.
4. Gently push the SIMM into an upright position until it locks into place.
5. Install the CPV5000 in the chassis and connect the power cords. Apply
power to the chassis.