19
Communications Gateway User Guide
Cabling and Startup for a Single User, continued
Introduction
Before You Begin
Installation & Configuration
FAQ
Troubleshooting
Glossary
License
X
Home
Exit
19
To connect the telephone line(s), plug a telephone wire into one or both phone jacks.
Caution
20
To connect to the Internet, connect your computer to the Communications Gateway
using USB or Ethernet:
USB:
Be sure the Motorola Communications Gateway CD-ROM is inserted in your
CD-ROM drive.
Connect the USB cable to the USB port on the Communications
Gateway. Connect the other end to the USB port on your computer. Then perform
“Setting Up a USB Driver”
on page 21.
Ethernet:
Connect the Ethernet cable to the Ethernet connector on the
Communications Gateway. Connect the other end to the Ethernet port on your
computer.
Ethernet users do not need to set up a USB driver.
If you connect to a wired telephone wall jack, be sure it is not connected to
a traditional telephone (
PSTN
) service.
P/N : 47 62 03 - 00 1 M ad e i n T ai w an , R . O. C .
CM H FC M AC ID : A B CDE F 01 23 45
CU S TOM E R S/ N : B CD EF G HJK L MN P
S/N : PPP P MM Y Y JJ JS SSS S CK A ABB C CC C
MT A MA C I D: A B CD EF 01 23 45
Caution
Do not connect
both
the Ethernet
and USB cables to the same
computer.
To power outlet
To cable outlet
To Ethernet or USB
(
connect only one to a
single computer
)
To telephone lines
Summary of Contents for Communications Gateway
Page 82: ...493049 001 3 02 English MGBI ...
