Motorola 700 Series, Installation And Use Manual

Page: 33 / 156

Block Diagram
1-19
1
battery as a power source, whether primary or secondary, it is
necessary to reconfigure the jumpers on J14 before installing the
board. Refer to SRAM Backup Power Source Select Header (J14) on
page 2-6 for available jumper configurations
The power leads from the battery are exposed on the solder side of
the board. The board should not be placed on a conductive surface
or stored in a conductive bag unless the battery is removed.
!
Warning
Lithium batteries incorporate inflammable materials
such as lithium and organic solvents. If lithium batteries
are mistreated or handled incorrectly, they may burst
open and ignite, possible resulting in injury and/or fire.
When dealing with lithium batteries, carefully follow
the precautions listed below in order to prevent
accidents.
❏
Do not short circuit.
❏
Do not disassemble, deform, or apply excessive pressure.
❏
Do not heat or incinerate.
❏
Do not apply solder directly.
❏
Do not use different models, or new and old batteries
together.
❏
Do not charge.
❏
Always check proper polarity.
To remove the battery from the module, carefully pull the battery
from the socket (BT1, shown in Figure 2-1).
Before installing a new battery, ensure that the battery pins are
clean. Note the battery polarity and press the battery into the
socket. No soldering is required.