Steps to Strap Ethernet Card
Follow these steps to set Ethernet strapping.
Step
Action
1
Remove the enclosure.
2
Remove the rear filler panel above the daughtercard.
3
Remove the two screws attaching the daughtercard panel to the rear panel
of the Vanguard 300.
4
Remove one screw attaching the daughtercard to the standoff on the
motherboard.
5
Carefully, by applying equal force at both ends, pull off the daughtercard
until it unplugs from the header.
6
Set the strapping as shown in Figure 4-5.
7
Reassemble the Vanguard 300.
Example of Setting Ethernet Strapping
Figure 4-5 shows the strapping for the Etherne t interface.
Figure 4-5. Strapping the Ethernet Interface