7.19.3.4
Disabling the Sensor
This feature disables the sensors temporarily or permanently from sending the sensor events to the
system.
NOTE:
The feature is only applicable to holster sensor and weapon fired sensor. Vest pierced
sensor cannot be disabled.
7.19.3.4.1
Disabling the Sensor Temporarily
Procedure:
1
Short-press the preprogrammed
Sensor
button to activate the sensor timer.
The following scenarios affect the sensor state:
• If a gun or taser is removed from the holster within the timer duration, the timer stops
and switches the sensor to disabled state. A tone sounds and the radio displays
Sensor
Disable
.
NOTE:
The radio enables the sensor only when all the guns or tasers are placed into
the holster. A tone sounds and the radio displays
Sensor On
temporarily.
• If the timer expires without an event, a tone sounds, the radio switches the sensor to enabled
state, and clears the sensor status from the display.
• If the preprogrammed
Sensor
button is long-pressed, the OTA sensor notification is enabled.
7.19.3.4.2
Disabling the Sensor Permanently
Procedure:
1
Long-press the preprogrammed
Sensor
button to permanently disable the sensors.
A tone sounds and the radio displays
Sensor Off
. While in this state, no events is reported
over-the-air (OTA), regardless of how many times the gun is drawn, re-inserted or weapon is
fired.
The radio generates a bad key tone if the sensor is not allowed to be disabled or there is
no sensor connected to the radio when the preprogrammed button or menu select button is
pressed.
2
Long-press the preprogrammed
Sensor
button again to enable the OTA Sensor notification.
A tone sounds, and the radio displays
SNSR OFF
.
7.20
ASTRO 25 (P25) Programming Over Project 25 (POP25)
Also called Over-the-Air Programming, this feature allows configuration data and firmware to be
upgraded to your radio over-the-air. Full use of the radio is retained during the data transfer without
interrupting communication.
MN006727A01-AE
Chapter 7 : Advanced Features
65