7.9.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. Contact your system administrator for more
information.
Procedure:
1
Perform one of the following actions:
If…
Then…
If the emergency mode is ini-
tiated by other radios,
press and hold the
Side Button 1
and press the
Emer-
gency
button.
If the emergency mode is ini-
tiated by the Supervisor,
Perform one of the following actions:
• Press and hold the
Emergency
button.
• Press and hold the
Side Button 1
, and press the
Emergency
button.
• Wait for console to clear emergency.
NOTE:
The combinations of the following buttons are supported in your radio:
• Radio
Side Button 1
and
Top (Orange)
button.
• Radio
Side Button 1
and accessory
Orange
button.
• Accessory
1-Dot Button
and radio
Top (Orange)
button.
• Accessory
1-Dot Button
and accessory
Orange
button.
7.9.5
Sending an Emergency Alarm
When and where to use:
This feature allows you to send a data transmission, which identifies the
radio sending the emergency, to the dispatcher.
NOTE:
The default timer of
Emergency
button press to activate Emergency is 1000
milliseconds. This timer is programmable from 50–6200 milliseconds by a qualified technician.
Procedure:
Press the preprogrammed
Emergency
button.
One of the following scenarios occurs:
• The display shows
EMERGENCY
and the current zone or channel. You hear a short medium-
pitched tone and the LED blinks red momentarily.
• The radio sounds a short low-pitched tone to indicate that the selected channel does not
support emergency and rejects to launch emergency mode.
When you receive the dispatcher’s acknowledgment, the display shows
ACK RCVD
. Four tones sound,
the alarm ends, and the radio exits the Emergency Alarm mode.
If no acknowledgment is received, the display shows
NO ACK
. The alarm ends and the radio exits the
Emergency Alarm mode.
MN006727A01-AE
Chapter 7 : Advanced Features
46