12
1
2
3
4
5
6
7
8
50mm
EN
FIX BAR SUPPORTS
03. INSTALLATION
You should now set its length so that you can then place the support as shown in the image below.
The bar should exceed the position of the support arm by 50mm.
After placing the bar to the desired size, secure it with the
two self-tapping screws to the fixed part of the rod.
When the bar length is established, set the location of the rod holder
to ground.
If the height of the support arm is misaligned to the height of the bar you will have to adjust the arm
height. To do this follow these steps:
Drill two holes in the installation location to secure the
support with screws and dowels.
Loosen the support arm locking pin with a hex wrench
Fit the hole in the support to the bolts already in place
and tighten with the female screws.
Raise or lower the support arm to place the support to the height necessary to support the barrier.
Place the protective covers of the females.
Tighten the support arm lock pin with to lock
the support in the set position.
•
SET EXTENDING BAR LENGTH
•
BAR SUPPORT (FIXED) APPLICATION
•
ADJUSTING SUPPORT (FIXED) HEIGHT
4
7
5
8
1
2
3
6
