8
3
2
1
5
2
4
EN
AUTOMATISM INSTALLATION
03. INSTALLATION
This adjustment should be done only when the shoe cement is dry to prevent barrier
dislocation.
CEMENT MUST BE COOL
IN STEPS 1 AND 2
Mount the bolts and screws to the mounting
plate as exemplified in step .
With the cement still fresh, apply the fixing plate
so that the bolts and the female studs enter at
least 65mm into the cement.
*
If you are installing the engine on an existing
shoe, bolt the mounting plate to the floor using
screws and dowels as shown on page 7B (not
supplied in the kit).
Using a level, make sure the plate is perfectly
horizontal.
Once the cement has dried, remove the upper
females to apply the barrier.
Route the electrical cables to connect the engine to the accessories and power supply. Leave cables
of a length that ensures easy connection to the control panel at the top of the barrier.
Position the barrier on the plate leaving it centered and secure it by tapping the screws inside the
barrier.
1
2
3
4
5
Mín. 65mm
•
ADJUST BARRIER POSITION
*Once fixed at the ground, the SIGMA is ready to allow a position adjustment of a few
millimeters. Adjustment is made by rotating the barrier in relation to its center.
Allow the plate clamping females some
clearance to rotate the barrier.
Allow the plate clamping females some
clearance to rotate the barrier.
Retighten the females to secure the barrier
in the set position.
1
2
3
1
