1
2
3
5
6
2
3
4
1
355mm
470mm
400mm
7A
7B
EN
EN
03. INSTALLATION
03. INSTALLATION
REMOVE COVER AND PROFILES
SHOE
•
CREATE SHOE
•
EXISTING SHOE
Using the mounting plate, mark the holes in
the shoe.
Puncture the shoe at these markings and
apply appropriate wall plugs to secure the
barrier.
Open the door
Insert the key into the outer lock and turn it 90°
to open the door.
This barrier allows free access to the interior to facilitate the product installation and maintenance
process. To do so, remove the aluminum cover and profiles from the barrier.
Remove door
With the door fully open at 90° pull it upwards
until it comes out of the side profile
Frame the mounting plate with the floor
holes.
Unlock cover
Move the cover lever to the right (as shown) to
unlock the cover.
Remove Side Profiles
Do the same with the side and chrome profiles
to fully release the inside of the barrier.
*If you already have a shoe created, proceed
as follows:
1
2
Place the barrier on the floor mounting
plate, aligning the two with the holes in the
shoe.
Remove cover
Lift the cover carefully so as not to damage the
connecting cables.
Secure the barrier to the shoe with screws
from the inside so that it is fully fixed and
level.
3
4
•
REMOVE COVER
•
REMOVE PROFILES
1
5
2
6
3
Turn off flashing light connection
Disconnect the flashing light plug cable
integrated in the cover.
4
It is not necessary to remove the rear profile.
Drill a hole of 355x470mm and 400mm (or
greater) deep to create the fixing shoe.
Fill with concrete and smooth the top.
Apply the engine mounting plate to the
shoe with the cement still fresh (see page
8).
1
2
3
