INSTRUCTION
ML
50
0 HYDRAULIC LIFT
4-1
8
CHAPTER 4. INSTRUCTION
4-1 INSTRUCTION
Caution:
As with all electrically powered equipment be aware of wet conditions and
condition of the electrical cord to avoid electrocution. This product is intended for use
by professionals in the performance of mechanical repairs on powersports vehicles
and is to be considered dangerous if not maintained or if used improperly. Do not use
an extension cord to power the hydraulic pump
.
STEP 1.
Check product and bill of materials to make certain all required parts are
accounted for and in good condition.
STEP 2.
Unit should be placed on a concrete surface free from as many defects as
possible to prevent unit from tipping or rocking. Place unit in the area
intended for use and adjust to make certain that unit is level and stable.
Unit should be in close proximity to
22
0volt electrical outlet.
STEP 3.
Prior to loading a motorcycle, the lift should be cycled 2-3 times to verify
proper operation. Inspect remote control and determine if up and down
buttons are functioning properly. Inspect pump for oil, open filler cap to
add oil if needed.
STEP 4.
Raise lift to comfortable working height (approx 35 inches) to make
certain that drop down panels (front and rear) operate smoothly. Slide
catches off of retention bolts and the panels will drop down, make certain
to hold onto the panel and not let it fall freely.
Caution
:
Never operate lift while drop down panels are in the down position. Return
them to the level position until the safety lock is set.
STEP 5.
Loosely attach vice rails in the appropriate holes in deck of lift, slide vice
into rails and make certain there is clearance to allow a smooth sliding
motion. Tighten rails to deck and recheck sliding of clamp. Tighten pinch
bolts to hold vice to deck of lift.
STEP 6.
Attach ramp to rear of lift while in down position.
Caution
:
Do not leave ramp attached to lift while in operation or in up position.
STEP 7.
Always use tie downs to secure vehicle to lift while operating.
STEP 8.
If applicable, attach side extensions, as needed using the supplied
hardware.
