© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANULDNSINS003
03-21-18
www.motorcitywashworks.com
21
ahead of the vehicle. The signal can be any voltage between
24 to 240 VOLTS AC or
DC.
ONE SIDE WHEEL READY SIGNAL (FOR THREE WHEELS SYSTEM ONLY!):
This
signal will bring the side wheels in. The signal has to be program to bring the side
wheels in soon enough in order to meet ahead of the vehicle. The signal can be any
voltage between
24 to 240 VOLTS AC or DC.
ONE E-STOP OK SIGNAL (FOR SAFETY PURPOSE):
This signal will enable the Dry
N’Shine and its components to
RUN IF ANY OF THE WASH E-STOP IS NOT
PUSHED
. The signal has to be always
ON
and then turns
OFF
if any of all the wash
emergency stop button is pushed. The signal can be any voltage between
24 to 240
VOLTS AC or DC.
IMPORTANT NOTE:
THE SONAR READY SIGNAL IS TRIGGERED BY THE SONAR
PHOTO-EYE WHERE THE EMITTER IS MOUNTED ON THE
CROSSBEAM LEG CLOSE TO THE FLOOR AND THE RECEIVER ON
THE TOP WHEEL FRAME BESIDE THE TOP WHEEL 3 POSITIONS
CYLINDER BASE. IT IS SHIPPED UNMOUNTED. MOUNT THE
PHOTO-EYE ASSEMBLY WITH THE RECEIVER POINTING TOWARD
THE EMIITER TO THE FLOOR. IT IS AN IMPORTANT COMPONENT
OF YOUR DRY N’SHINE SYSTEM.
MANY SAFETY FEATURES BUILT IN YOUR DRY N’SHINE SYSTEM
DEPENDS ON THE SONAR READY SIGNAL AND ITS ACCURACY.
INSURE THAT BOTH HOOD SENSOR AND SONAR READY PHOTO-
EYES ARE NOT “CROSS TALKING”.
VERY IMPORTANT SAFETY ISSUE:
AN EMERGENCY STOP BUTTON IS PART OF A SYSTEM INTENDED FOR USE IN
EMERGENCY CONDITIONS TO TRY TO LIMIT OR AVERT HARM TO SOMEONE OR
SOMETHING BECAUSE OF THE AUTOMATIC NATURE OF THE DRY N’SHINE
START AND STOP. THE E-STOP OK SIGNAL BECOMES A CRITICAL PART OF
YOUR WORKERS AND/OR PUBLIC PROTECTIVE MEASURES.
UNDERSTAND AND INTERCONNECT THE CAR WASH EMERGENCY STOP CIRCUIT
WITH YOUR DRY N’SHINE CONTROLLER SHOULD BE RECOGNIZED HAS A
PRIORITY FOR YOUR INSTALLER AND/OR ELECTRICAL CONTRACTOR.
IT IS THE CUSTOMER RESPONSIBILITY TO PROVIDE THE DRY N’ SHINE SYSTEM
WITH THE PROPER E-STOP OK SIGNAL. IF YOUR CAR WASH CONTROLLER
DOESN’T HAVE A DEDICATED E-STOP CIRCUIT EQUIPPED WITH A “MASTER”
EMERGENCY CONTROL RELAY, INSTALL AND USE THE SUGGESTED
EMERGENCY CIRCUIT RELAYS SHOWN BELOW. THE CIRCUIT SHOWN HAS BEEN
DESIGNED FOR WASHES USING ICS WBC CONTROL BOARD BUT CAN BE USE
WITH OTHER CAR WASH CONTROLLER. CALL FACTORY FOR HELP IF YOU HAVE
ANY QUESTION CONCERNING THE REQUIREMENT FOR DRY N’ SHINE E-STOP OK
SIGNAL.
MOTOR CITY WASH WORKS TEL: 866.FOAMERS (8:00-17:00 ET)
248.313-0272
