MOTO GUZZI Engine V1100, Workshop Manual

Page: 103 / 108

GEARBOX
4 - 24
Engine V1100
4.2.2. CHECKING THE COMPONENTS
Clutch springs
Check the springs for yielding and deformation:
•
Springs compressed to 22 mm (0.8661 in) should give
a load of 11.25 - 11.70 kg (24.80 - 25.79 lb);
• Springs compressed to 20 mm (0.7874 in) should have
a load of 14.75 - 15.30 kg (32.52 - 33.73 lb);
Spring pusher plate
Check that the plate is not worn at the hole where the
retainer works, and that surface mating with the driven plate
is perfectly flat.
Check that the toothing inside the flywheel is in good
condition.
Driven plates
Check that the surfaces mating with the driven plates are
perfectly smooth and flat and that external teeth working
inside the flywheel are not damaged; replace the plate, if
necessary.
Starter gear wheel
Check that the surface mating with the driven plate is
perfectly smooth and flat.
Also check toothing where the starter motor sprocket works;
make sure it is not damaged or worn;
change the gear if necessary.
Clutch inner body
Check that the teeth are not worn in the areas in contact with
the plates.