Installation
15
Manual # 42-02-U001, Rev C1
• RUN DOWN OUTPUT: Terminals DWN, CM5. This output contact will activate (close)
when TAPS determines that the controller must move in the down direction.
• FAULT MONITOR OUTPUT: Terminals NF, CM8. TAPS constantly monitors the sta-
tus of the UPS. This output contact will deactivate (open) when there is a problem with the
UPS. This output can be used as part of the control monitoring system.
.
• E-01: The UPS has reported a failure. This error is displayed immediately.
• E-03: Communication between UPS and TAPS has failed. This error is displayed after
about 1 minute.
Note
Some elevator controllers will not require all TAPS outputs — some outputs may be unused for
your application. Contact MCE Technical Support at 916 463 9200 if you have questions.
TAPS Connection Tables for MCE Controllers
The following tables provide TAPS relay closure output connection points for MCE elevator
controls.
Note
For existing MCE controllers, a software upgrade will be required. Depending on the controller
model, hardware modification may also be required. Please contact MCE with the type and soft-
ware revision level of your controller.
Table 6. TAPS Connections
TAPS Signal
TAPS Terminal
MCE Controller
Backup Power On
UPS1
CM3
BPCR input
2 Bus
Reverse Direction
REV
CM6
REVD input
2 Bus
Fault Monitor
NF
CM8
FLTM input
2 Bus
Summary of Contents for TAPS
