27
5.12 Restore factory default for intensity
(Panthera C2)
●
Turn the microscope off by switching the main switch on the backside of the microscope to off.
Keep the intensity knob pressed and switch microscope on.
Keep holding the intensity control knob for 10 seconds.
The system has been reset to factory values.
Default intensity value for each objective is defaulted at 10% of total
brightness.
5.13 Turn off light manager
●
The light manager enables the microscope to remember the best illumination setting from previous
usage. When the microscope is set at the best illumination with objective A, light intensity will be
remembered. You can switch to objective B and adjust the illumination.
When you switch back to objective A, the light intensity will return to its last setting. The light
intensity of all five objectives can be remembered.
●
The light manager feature can be disabled by pushing the intensity knob (Fig. 17) for 5 seconds.
The LED indicator will reduce its intensity from the maximum to the minimum, indicating that the
light manager is disabled. To re-activate the light manager, use the same process.
●
If you do not touch the microscope for 30 minutes, it will go into ECO mode. The lowest layer of
the LED indicator will “breathe” (blink slowly). Any movement of the nosepiece or the intensity
knob will re-activate the microscope.
●
The ECO mode can be disabled by triple clicking the intensity knob (i.e: in the case of extended
video shooting). The LED indicator will illuminate once when ECO mode is disabled. Triple clicking
the intensity knob again will reactivate ECO mode. (Fig. 17)
(Fig. 17)
