Mosquito Magnet Liberty Pluse, Operation Manual

Page: 5 / 18

8
Set-Up
7
Set-Up
Propane Tank Installation
1. After trap is placed in its ideal location,
place propane tank onto the molded cradle.
2. Making sure propane tank is fully closed.
Attach propane regulator hose to propane tank.
Secure tightly by hand.
Do not use tools.
3. Turn propane on by slowly turning valve counter-
clockwise. Take care not to turn too quickly to avoid
engagement of safety valve.
DO NOT MOVE TRAP WITH TANK ATTACHED!
TANK MUST BE DISCONNECTED FROM REGULATOR
BEFORE TRAP IS RELOCATED TO AVOID DAMAGE
TO REGULATOR AND/OR TRAP. BE ADVISED,
DAMAGE CAUSED FROM FAILURE TO COMPLY
WITH THIS INSTRUCTION IS NOT COVERED
UNDER WARRANTY.
Trap Placement
1. Determine the direction of the prevailing wind.
Check local weather patterns if you are unsure.
2. Stand in the center of the area you are trying to protect
and look toward the prevailing wind.
3. Proper placement of the Liberty Plus will be 30 – 40 feet
in front of you, within 5-6 feet of ground cover (i.e. bushes,
flowerbeds, tree line, marshbed). Ensure that trap is not
directly against any blockades such as buildings, fences, etc.
4. It is recommended that the trap be placed in the shade.
5. Do not place trap directly above a water source
(sprinklers, hose, etc.).
6. Trap must be placed on level ground to avoid tipping
or uneven propane distribution.
7. For optimal trap placement in your yard, refer to the
instructional CD-ROM included with your Liberty Plus.
Charging your Mosquito Magnet ® Liberty Plus
1. Remove cover panel from rear of Power Head Unit
(panel snaps off).
2. Insert and connect re-chargeable battery.
3. Insert Charging Adapter into rear of Head Unit.
Allow to charge for 24 hours at the beginning of each
season. You will not need to charge again until next season.
Replace cover panel when completed (panel snaps into place).
NOTE: Unit must be charged indoors, trap is not
weatherproof with cover panel removed.
Remove Back Panel
Insert & Connect Battery
Plug Charger Into Battery Charging Powerhead
Step 1 – Propane Tank Placement
Step 2 – Attach Regulator
Step 3 – Slowly Open Valve