Mortara X12 Plus, User Manual

Page: 16 / 46

ELECTROMAGNETIC COMPATIBILITY (EMC)
xiv
Guidance and Manufacturer’s Declaration: Electromagnetic Emissions
The equipment is intended for use in the electromagnetic environment specified in the table below. The customer or
the user of the equipment should ensure that it is used in such an environment.
Emissions Test Compliance Electromagnetic Environment: Guidance
RF Emissions
CISPR 11 Group 2 The equipment must emit electromagnetic energy in order to
perform its intended function. Nearby electronic equipment may
be affected.
RF Emissions
CISPR 11 Class B The equipment is suitable for use in all establishments including
domestic establishments and those directly connected to the
public low-voltage power supply network that supplies buildings
used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2 Not Applicable
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3 Not Applicable
Guidance and Manufacturer’s Declaration: Electromagnetic Immunity
The equipment is intended for use in the electromagnetic environment specified in the table below. The customer or
the user of the equipment should ensure that it is used in such an environment.
Emissions Test Compliance Compliance Level Electromagnetic Environment: Guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2 +/- 6 kV contact
+/- 8 kV air +/- 6 kV contact
+/- 8 kV air Floors should be wood, concrete, or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30%.
Electrical fast
transient/burst
IEC 61000-4-4 +/- 2 kV for
power supply lines
+/- 1 kV for
input/output lines Not Applicable
Surge
IEC 61000-4-5 +/- 1 kV differential
mode
+/- 2 kV common
mode Not Applicable
Voltage dips,
short
interruptions, and
voltage
variations on
power supply
input lines
IEC 61000-4-11 <5% UT
(>95% dip in UT)
for 0.5 cycle
40% UT
(60% dip in UT)
for 5 cycles Not Applicable
Power frequency
(50/60 Hz)
magnetic field 3 A/m 3 A/m Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
NOTE: UT is the AC Mains voltage prior to application of the test level.