Morso P30, Instructions For Installation And Use Manual, Page: 14 / 21

26 27
Sprog
Sprog
Recommendations
• Turn off the pellet stove in the event of failure or poor function using key P3.
• Do not add pellets to the burn pot by hand.
• Accumulations of unburnt pellets in and below the burn pot after an unsuccessful at-
tempt at lighting must to be removed, before attempting re-lighting.
• Never add fuel other than timber (white) pellets to the pellet hopper and burn pot.
• The pellet stove may only turned on using the automatic ignition system.
3.0 Regular maintenance of the stove
3.1 Cleaning
To ensure optimal function and safety of your pellet stove, regular maintenance and cleaning
are needed.
Before doing this, ensure that:
•
All parts of the pellet stove have cooled down
• Embers are extinguished and the ash is completely cold
• The main switch on the pellet stove is set to 0.
Unplug the power cable to prevent unintentional power supply.
IMPORTANT!
OBSERVE CAREFULLY THE FOLLOWING GUIDELINES FOR CLEANING! LACK OF MAINTE-
NANCE CAN LEAD TO FUNCTIONAL PROBLEMS FOR THE PELLET STOVE
Overview of cleaning
Parts/ frequency Daily 2-3 days 30 days 60-90 days Each season
Burn pot (p.27) •
Ash drawer (p.28) •
Glass pane (p.32) •
Smoke baffle (p.29) •
Flue (p.30) •
Glass fibre rope (p.32) •
Cleaning rod (p.28) •
Chimney (p.7) •
Firebox (p.29) •
Vacuum cleaning of
pellet hopper (p.32) •
Cleaning of surfaces
Use a cloth wrung in water or mild soapy water to cleaning the enamelled metal parts. Use of
aggressive cleaning materials or solvents damage the surfaces of the pellet stove.
Cleaning burn pot before each ignition
Check that the burn pot, in which combustion takes place, is clean and that slag and remnants
are not clogging the holes in the base of the burn pot. This guarantees optimal combustion in
the pellet stove. this in turn prevents any overheating, which can lead to changes in colour of
the varnish or spalling of the lid, and even ignition failure. The burn pot can be turned incor-
rectly. It is important that the hole for the ignition tube faces the ignition tube and lies flat.
Remember also to clean below the burn pot.
IMPORTANT!
SURFACES OF THE STOVE BECOME HOT DURING OPERATION! THEREFORE ALWAYS
WEAR GLOVES TO TOUCH IT, FOR EXAMPLE WHEN FILLING THE PELLET HOPPER.