Morris CX 8105, Operator'S Manual

Page: 113 / 182

Monitor
CX 8105 - Ground Drive December 2016 6-27
Sensor Replacement
The monitor will alarm the operator if there is a faulty
sensor in the system by displaying a communication
error for the sensor.
To replace a faulty sensor follow the steps below.
Example: Replace Shaft 1 sensor.
1. From the “Operating Screen” press the MENU key
to enter the “Settings Menu”.
Use the Up/Down keys to highlight “Installation” press
the SELECT key to enter the function.
2. Use the Up/Down keys to highlight “Replace a
Sensor” press the SELECT key to enter the function.
3. The monitor will highlight “Select Sensor” press the
SELECT key to enter the function.
Use the Up/Down keys to display desired sensor to
be replaced (i.e. Shaft 1), press the SELECT key to
accept selection.
4. “Proceed” will now be highlighted, press the SELECT
key to enter mode.
5. The monitor will then display “Plug in new sensor for:
Shaft 1”. Unplug the old sensor and plug in the new
sensor.
6. Once the monitor acknowledges the new sensor, it
will emit a double beep and acknowledge that the
sensor has been replaced.
“Exit and Save” will be highlighted, press the
SELECT key to save the changes and return to the
“Installation” menu.
7. Use the Up/Down keys to highlight “Exit” press the
SELECT key to return to the “Settings Menu”.
Note: Sensors can also be added or removed from
the system in the same manner by slecting
the choice from step 2.
1
2
3
4
5
6
7