25
TriStar MPPT 600V Operator’s Manual
24
Installation
Solar Wiring
Battery Wiring
Communication
Wiring
Figure 3-6. Wiring pass-through paths between multiple controllers
3.4 Controller Preparation (TS-MPPT-60-600V-48 and
TS-MPPT-60-600V-48-DB)
Step 1 - Remove the Wiring Box Cover
CAUTION: Shock Hazard
Disconnect all power sources to the controller before removing the wiring box cover. Never
remove the cover when voltage exists on any of the TriStar MPPT 600V power connections.
PRUDENCE : Risque de décharge électrique
Déconnectez toutes les sources d’alimentation du contrôleur avant d’enlever le couvercle
du boîtier de câblage. Ne retirez jamais le couvercle en présence de tension sur une des
connexions d’alimentation du TriStar MPPT 600V 600V600V.
!
!
Use a #2 Phillips screw driver to remove the four (4) screws that secure the wiring box cover as
shown in figure 3-7 below.
Figure 3-7. Remove the wiring box cover
Step 2 - Remove the Wiring Divider (TS-MPPT-60-600-V48 and TS-MPPT-60-
600V-48-DB) and Solar Terminal Bridge (TS-MPPT-60-600V-48 ONLY)
The wiring divider separates the solar high voltage wiring from the low voltage battery and
communication circuits. See Figure 3-8 . The divider is secured with only one screw.
1. Use a #2 Philips screw driver to remove the screw.
2. Lift and tilt the divider towards the bottom of the unit as shown in Figure 3-8.
3. Lift the divider out of the wiring box and set the divider and screw aside. The divider
must be replaced in a later step.
