Morita Tri auto mini, Setup Instructions

Page: 9 / 40

Operation 2011-07-05 8
1 2
Charge Battery
Green LED
Orange LED
Temperature: 10 to 40°C (50 to 104°F), Realtive Humidity: 30 to 75 %RH (without condesation),
Atmospheric Pressure : 700 to 1,060hPa
* If the unit has not been used for some time, make sure it works properly before using it again.
The battery is built into the motor handpiece.
• The battery is not charged when the unit is shipped from the factory and must be charged before using the unit.
• Do not pull or yank the cord when disconnecting the AC adapter. Always grip the connectors.
• Use only the power cord provided and plug both ends all the way in.
• Charger and power supply cord must be located outside the so called patient environment (2.0 m around the patient location).
• If an electrical storm occurs while the battery is being charged, do not touch the charger or its cord as there would be a risk receiving an electric shock.
• Do not get the charger wet or use it where it might get wet.
Usage
⹅
Operation Conditions for the main unit and AC adapter
Charge the battery as soon as the battery power indicator gets down to its last bar.
If the orange charge LED goes off immediately or doesn’t light up when the handpiece is put into the charger, the battery is probably fully charged.
To make sure, take the handpiece out and put it back in again.
Make sure the contact areas for the handpiece and charger are free of debris, especially metal fragments. Wipe with ethanol to remove any foreign debris.
Do not press down too hard to wipe the charging areas; this could bend the electrical contacts.
Do not leave the charger where it will be exposed to direct sunlight.
Do not use any charger; use only the one that comes with the Tri
Auto mini.
Connect the power cord to the charger and then plug
it in. Turn the charger on. The green Power LED will
light up.
* Ambient (room) temperature for charging is from 10ºC (50ºF) to 40ºC (104ºF).
Put the handpiece into the charger as far as it will
go. The orange Charge LED will light up to show that
charging has begun.
* Charging time is about 120 minutes.
Green LED
(1) Before Use