Page 37
DocuFold Pro
PAPER
FOLDER
NO POWER TO MACHINE
If the touchscreen display fails to come on, check that isolator switch (S) is not pressed in.
To release, turn knob clockwise.
Check power supply to the machine.
MAIN SWITCH CUTS OUT:
The feeder will cut out automatically after 100 seconds if the main switch is left on
without the feed switch being activated.
The compressor inside the machine requires up to 28 amps to start running. You must
have the machine plugged directly into a 30-amp ring main. Do not attempt to run the
machine with an extension lead.
The main switch will cut out if you have a paper jam or overlap is indicated.
FOLD ROLLER REPLACEMENT:
Your Morgana Docufold Pro has been designed to make fold roller replacement an easy and
low cost operation. Your local sales agent will be able to supply you with a complete
replacement roller assembly which allows you to change the roller assembly yourself as
described in the roller assembly removal section of this manual. You will need to send
back to your agent the existing roller assembly.
Page 36
PAPER WILL NOT STACK CONSISTENTLY:
Make sure the feed is consistent before attempting adjustments to the Delivery Roller.
Set the delivery roller position as described in the manual. Sometimes a small repositioning of
the roller will improve the stacking. See Delivery Roller (Page 19)
If the paper is too curly when being delivered, place the catch tray and plug in perforating unit
with blades disengaged into position and deliver out the back. This applies to single fold
applications only. If two folds are required, you may need to reduce the weight of stock to
achieve the desired results.
PAPER WILL NOT DEFLECT WHEN USING ONE FOLD OR PERFORATING:
Check to make sure that the second plate is being used as the deflector.
Make sure that the plate is located securely and that the deflector bar is wound right to the end.
Set the tilt roller mechanism to zero.
Check that the material is not too heavy to deflect.
TOTAL AND BATCH COUNTER NOT WORKING:
Clean the sensors as described in the manual.
OVERLAP ERROR KEEPS APPEARING ON TOUCHSCREEN
If the overlap keeps tripping in and cutting off the machine, first check you are not feeding
doubles and reset the feeder.
Overlap tripping can also mean that the machine is slowing slightly which may mean the
material is too heavy.
Check that you have no foreign bodies or torn paper stuck inside the fold plates or machine.
MACHINE WILL NOT RESET
Your Docufold Pro is a mini computer; you must have a clean consistent power supply. Switch
off at power switch (S), wait 20 seconds and re-power.
