Page 37
SYSTEM
Adjusting the blade pressure (no paper required)
1. (i) Switch the power ‘on’ by turning the Emergency stop button clockwise to release the
safety latch.
(ii) Select the Tools tab
at the bottom of the touch screen, the display will
change to that shown below.
(iii) Activate the system switch to ‘ON’
(iv) Select the up arrow to move the blade to the Top Dead Centre position.
2. Raise the exit guard
3. Using a 5mm allen key, unlock the socket head screws positioned at each end of the
creasing blade.
4. Rotate the blade adjustment cams until they are just tight, and then back off slightly
before tightening the socket head screws.
The diagram below demonstrates the adjustment of the blade pressure
Click on Up Arrow to
put Anvil into Top
Dead Centre position
(TDC)
5
The Blade Assembly
DigiFold Pro
