Morgana BM 2000, Operator'S Manual

Page: 22 / 59

21
1. Basics
Before inserting the stapler head, centre the
stapler lift bracket (D) over the area that will
receive the stapler head. Ensure that the staple
driver post (E) is in its uppermost position.
Place the stapler head back into the BM 2000.
The driver post arm (E) must be placed into the
stapler lift bracket (D).
Removing/replacing Stapler Head, continued
Note
Whenever you remove a stapler head, be sure to
manually eject some staples before replacing it in the
BM 2000. To do this, rest the stapler head on a firm
surface (for example, the top of a table) and actu-
ate the staple driver post up/down through full travel.
Do this a number of times to ensure that the staples
are ejected on each down movement. If you need
to change the staple cartridge, see previous section,
removal/replacement of staple cartridge.
Warning
When manually ejecting the stapler, stay clear from
stapler output area.
Secure the locking pin by rotating it towards the
in-feed side until it snaps in position (G). Check
that the stapler head is correctly mounted by
pushing the stapler head towards the infeed area.
If it is still loose, it is not correctly mounted.
Insert the staple detection lead (C) into its socket.
Press on the lower front edge of the stapler head
to align the hole (F) in the stapler bracket with the
hole in the stapler head. Insert the locking pin (B)
so that it engages the stapler head and the metal
sides of the stapler assembly.
Caution
If the driver post arm is not correctly positioned into
the stapler lift bracket (D) it will cause permanent
damage to the stapler head as well as the bracket.
Subsequently, also future correctly mounted stapler
heads will be damaged.
E
D
F
G