Morgana BM 2000, Operator'S Manual

Page: 20 / 59

19
1. Basics
Staples, Staple Cartridge, Stapler Head & Clinchers
Removing / replacing Staple Cartridge
A
You may remove and replace the staple cartridge
while the stapler head assembly is in place.
Open the top cover.
Raise the staple cartridge locking lever (A) as
indicated in the drawing.
Gently twist the staple cartridge (B) from side to
side, and pull out the staple cartridge (B) from the
stapler head.
B
If the staple cartridge is empty or allmost empty*,
discard it and replace it with a new one. Before
replacing the cartridge, pull at least 20 mm of the
staples out and tear off at the staple tear line (C)
which is marked on the cartridge. If there has been a
misfeed, and the cartridge still contains staples, pull
20 mm of staples out of the cartridge and tear off at
the stapler tear line. Check that the first staple is flat.
If not, tear off another 20 mm, using less force.
*
containing 00 staples or less
C
Insert the cartridge into the stapler head with the
staples facing towards the head mechanism. The
cartridge should be placed flat on the slide on the
bottom of the stapler head. Push the cartridge firmly
into the stapler head and keep holding it pressed.
While holding the staple cartridge firmly pressed
into the stapler head, push down the cartridge
locking lever.
Note
It is important that the cartridge not is allowed to move
away from the stapler head before the locking lever
is in engaged. If that occurs, remove cartridge and
again tear off 20 mm of staples along the staple tear
line before inserting the cartridge.
Replacing the staple cartridge