AutoCreaser Pro 33A
The stacker unit on the machine is used to catch the sheets once they have been
creased or perforated.
Setting the height adjustable stacker assembly
1.
Assemble the stacker unit to the machine as shown in Fig. 4 below.
Important
Ensure that the stacker unit has been assembled to the machine properly. However,
if it has not, the connection on the magnetic switch will be broken and the machine
will not operate (see Trouble shooting pages for details).
There are two side guides on the stacker unit; a left handed guide and a right handed le)
guide held on by a magnetic strip. There is also a back stop held on by a magnetic strip.
The guides will control the way in which the paper is collated by setting their
positions on the stacker bed.
2.
Place a single sheet (from the stack to be creased / perforated) on to the stacker bed
against the ‘left hand’ guide.
3.
Position the ‘right hand’ side guide on to the stacker bed leaving a minimum
clearance of approximately 1mm each side of the sheet.
4.
Whilst the sheet is between the two guides on the stacker bed, set the distance
between the top of the sheet and the backstop flanges to approximately 5mm - the
stacker height can be adjusted by using the handle on the operators side, the handle
must be pushed in to unlock, rotated & then pulled and locked into one of the locating
holes.
.
5.
For shorter sheets, the back stop can be used (as shown in Fig. 4) to adjust the
position of the paper stack.
Stacker Assy.
LEFT HAND
SIDE GUIDE
RIGHT HAND
HEIGHT
SIDE GUIDE
ADJUSTMENT
LEVER
BACK STOP
FIG. 4
Page 28
CREASING
TIPS
l
The magnetic back stop supplied with the machine
can also be used as a tool holder as demonstrated
in the photograph (left).
Page 28
Stacker Assy.
Page 29
SYSTEM
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
