6
7
IMPORTANT SAFETY INFORMATION
CONTROL PANEL
SETTING AND USING THE OVEN PROGRAMMER/TIMER
INSTALLATION
• This appliance must be correctly installed by a suitably qualified person, strictly in accordance
with the manufacturer’s instructions.
• We decline any responsibility for injury or damage, to person or property, as a result of
improper use or installation of this appliance.
• Heat, steam and moisture will be created during use of the appliance. Take care to avoid
injury and ensure that the room is adequately ventilated. If the appliance is going to be used
for prolonged periods of time, then additional ventilation may be required.
• Please consult with your qualified installer if you are in any doubt about the amount of
ventilation that you will require.
PARTS IDENTIFICATION
1. Control panel
2. Side shelf
3. Oven shelf
4. Oven door
5. Door handle
ACCESSORIES
6. Side shelf left
7. Side shelf right
8. Rottiserie
9. Oven shelf
10.Baking tray
M
$
8
7
2
1
2
3
4
5
6
7
10
9
8
M
$
8
7
2
1
2
3
4
5
6
7
10
9
8
1
2
3
4
5
6
7
8
9
10
11
12
13
1. Oven function selector knob
2. Power indicator light
3. Oven programmer/timer
4. Oven operating light
5. Thermostat control knob
6. LED display
1
2
3
4
5
6
7
8
9
10
11
12
13
OVEN PROGRAMMER/TIMER DISPLAY
7. Automatic function symbol
8. Oven in use symbol
9. Decimal point symbol
10. Minute minder symbol
11. Plus button
12. Manual button
13. Minus button
SELECTING MANUAL OPERATION MODE
After your appliance is connected to your power supply for the first time (or after a power-cut)
the numbers on the timer display will flash. Before you can select a cooking function or set a
temperature, you must first set the appliance into “manual operation” mode.
• To select manual operation mode, press the program button (12) for three seconds. The oven
in use symbol (8) will light in the display.
SETTING THE TIME OF DAY
After your appliance is connected to your power supply for the first time, you must set the time
of day before you can use the oven.
• Make sure the oven is in manual operation mode (as outlined above).
• Press the program button (12) once to set the time of day. Whilst the decimal point symbol
(9) is flashing, use the plus (11) and minus (13) buttons to set the correct time of day.
• When the correct time of day is shown on the LED display, release the plus and minus buttons
and wait a few seconds. The decimal point symbol (9) will stop flashing and the oven is ready
to use.
MBO-7700D(IM)061016_Layout 1 10/7/16 11:15 AM Page 4
