2
1.
Disconnect and isolate the battery negative cable.
2.
Using a trim stick C4755 or equivalent, work around
the perimeter of the bezel, and across the middle re
leasing the retaining clips (1) and separate the bezel
from the instrument panel.
3.
Disconnect the electrical connectors (1) and remove
the bezel.
4.
Remove the radio mounting fasteners.
CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector
could damage the cable or radio.
5.
Pull the radio out far enough to access the back of the
radio.
6.
Disconnect the AM/FM antenna (2) and electrical con
nectors (1).
7.
If equipped, disconnect the navigation antenna (3).
8.
If equipped, disconnect the USB connectors (4).
9.
Remove the radio from the instrument panel.
10. Position the new radio to the instrument panel.
11. Connect the AM/FM antenna (2) and electrical con
nectors (1).
12. Connect the satellite/navigation antenna (3).
13. If equipped, connect the USB connectors (4).
14. Install the radio mounting fasteners.
Dec 31, 2010
K6861192
