5
28. Drill a 13mm. (0.5 in.) hole in the drivers side front
lower corner of the storage compartment, forward to
ward the instrument panel.
29. Route the WiFi electrical harness through the hole
and connect to the router.
30. Squarely position the router near the hole and secure
in place with the materials provided.
31. Route and secure the WiFi power harness (2) from
the rear quarter panel, along the passenger side and
underneath the door sill scuff plate.
32. Route and secure the WiFi power harness under the
glove box opening and behind the center stack and
cut the harness to the proper length.
33. Locate the cigarette lighter outlet wiring harness.
34. Cut each wire and remove 13mm (0.5 in.) of insulation
from each wire that needs to be soldered/spliced.
35. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol
dered area.
CAUTION: Do not use acid core solder.
36. Solder the supplied fused pigtail to WiFi power har
ness power wire.
37. Place the strands of the power side wires overlapping
each other inside of the splice clip (1).
Oct 16, 2009
K6860899 Rev. 1