Manual Part No: 932971-01 MD Gas Convection Oven
Page 28 of 32
Manual Rev No: 1
Service and Maintenance (cont.)
10)
To Remove Fan and/or Motor.
From inside the oven cavity, remove the oven shelves and the fan guard, which is secured by four
fixing screws.
Remove the single fixing screw securing the fan, then withdraw the fan (this can be done using
the fan extractor, located at the rear of the appliance on the back panel, between the flues).
Working from the rear of the appliance, remove the electric’s cover, secured by four screws.
Disconnect the three wires from the terminal block plus the earth wire. Unscrew the four fixing
screws securing the motor and remove. Replace in reverse order.
11)
To Remove Ignition Switch.
Remove the control knobs and the control panel, which is secured by two fixing screws.
Working at the rear of the control panel, disconnect the wires to the switch - taking careful note
of their positions.
Push the switch through the control panel and at the same time squeeze down onto the two tabs
above and below the switch. Replace in reverse order.
12)
To Convert NG appliances to LP Gas. (Single & Two Tier Ovens)
Remove the oven furniture.
Switch off and disconnect the supplies.
Remove the oven burner (Section 2) and unscrew the injector.
Fit Aeration Plate (927438-01) to burner using the 1/8
”
pop rivets.
Fit replacement LP burner injector (924905-04). Unscrew the pilot supply pipe at the pilot
assembly and remove the pilot injector (Section 2).
Fit replacement LP pilot injector (922088-11).
On the solenoid valve, screw the governor “fully home” (that is clockwise).
Aeration Plate -
927438-01
Burner Injector -
924905-04
Pilot Injector -
922088-11
