Moore Tandem Uni-Drill DP400A, Instructions Manual

Page: 7 / 66

Safety Regulations
6
– When a leak is found, all
necessary precautions should be
taken to avoid accidents.
7
– Pressurized liquid, particularly
hydraulic circuit oil, may cause
serious injury if it comes into
contact with the skin. In the case
of injury, consult a doctor
immediately. There is a risk of
infection.
8
– Before any operation on the
hydraulic circuit, lower the
machine, release the pressure
from the circuit, turn off the engine
and remove the key from the
ignition.
MAINTENANCE
7
1
– Before commencing any
maintenance, servicing or repair
work, or before attempting to
locate the source of a breakdown
or fault, it is essential that the
power take-off is disengaged, the
engine turned off and the key
removed from the ignition.
2
– Check regularly that nuts and
screws are not loose. Tighten if
necessary.
3
– Before carrying out
maintenance work on a raised
machine, prop it up using
appropriate means of support.
4
– When replacing a working part
(seed drill coulter or disc etc)
wear protective gloves and only
use appropriate tools.
5
– To protect the environment, it
is forbidden to throw away oil,
grease or filters of any kind. Give
them to specialist recycling firms.
6
– Before operating on the
electric circuit, disconnect the
power source.
7
– Protective devices likely to be
exposed to wear and tear should
be checked regularly. Replace
them immediately if they are
damaged.
8
–Spare parts should comply
with the standards and
specifications laid down by the
manufacturer. Only use Moore
spare parts.
9
– Before commencing any
electric welding work on the
tractor or the towed machine,
disconnect the alternator and
battery cables.
10
– Repairs affecting parts under
stress or pressure, (springs,
pressure accumulators, etc)
should be carried out by suitably
qualified engineers with special
tools
Danger
A = Risk of crushing
B = Marker operating zone
C = Moving parts
D = Do not travel on the platform
E = Rotating agitator shaft
D
E
C
A
B