2
The Interface Solution Experts
ENTER
PASS
Enter the password
code to enable
settings changes.
(Default = 55)
Scale Input "Smart Scaling":
Set the values to be displayed
at zero and full scale without
calibration equipment.
Trim Output:
Connect the SPA into a calibration
setup as shown in the manual and
trim the analog output.
(Requires –AO Option)
Select Volt or Current Input:
Select input type. Defaults to mA.
Password:
View or change password.
Apply Input "Bench Scaling":
Using calibration equipment,
capture the zero and full scale
values.
Exit Configuration Menu:
Return to process display.
Configure Function Options:
Set engineering units, and custom
or standard linearization mode.
Security Jumper
installed in OFF position.
Security Jumper
installed in ON position.
VIEW current settings
Front Panel
Push Buttons
Inactive during operation.
Inactive during operation.
SELECT
Use or push buttons to scroll
through menus and sub-menus.
Use SELECT push button to access
menu and/or make a choice.
VIEW
SEL
V/I
CONF
OPTS
SCLE
INPT
APLY
INPT
TRIM
OUT
CONF
EXIT
CONF
ALRM
Configure Alarm:
Set trip point, deadband,
high\low trip, delay, and
latching\non-latching.
PASS
WORD
Enter Custom Curve:
Program up to 20 linearization
points into memory.
(This menu is only available if
SCLE
DSPL
Scale the Display:
Custom-scale the display.
(This menu is only available if
ENTR
CURV
Scale Analog Output:
Connect the SPA into a calibration
setup as shown in the manual
and trim the analog output.
(Requires –AO Option)
SCLE
AO
SPA HLPRG Quickstart Guide
Use the front push-buttons to quickly and
easily setup the SPA for your application.
After programming your alarm using the
diagram below, install the unit into your
application using the connection diagram
and terminal designation table on pages
35 and 36 of this manual.
