26
ADDITIONAL HIDDEN PARAMETERS IN SHIFT MODE
You can access the Sub Phatty’s additional hidden parameters using a combination of buttons and the
keyboard. First engage Shift mode by holding down the
BANK 4
button and pressing the
ACTIVATE
PANEL
button. Then enter a code from the hidden parameter chart using the
BANK
and
PATCH
buttons to select the parameter. Finally, press a key on the keyboard to select the parameter’s value.
All parameters have at least two possible values (ON and OFF), and some parameters have 24
possible values. Lower keys specify lower values, and higher keys specify higher values. Because
most parameters have a limited range of values, they respond to only the leftmost keys. The low C key
always selects the lowest value. For parameters with two values, the low C always selects OFF and
the low C# always selects ON. For parameters that use less than the entire keyboard to select values,
unused keys play normally, allowing you to audition sounds while you make parameter changes.
Middle C
KEYBOARD TRANSPOSE
To transpose the entire keyboard to any pitch you choose, engage Shift mode,
press the
BANK 1
and
PATCH 1
buttons, and then press any key. Pressing a key
above middle C transposes up by the interval you select. Likewise, pressing a key
below middle C transposes down by the interval you select. For example, if you
press A below middle C, you will transpose the keyboard down 3 semitones, and if
you press C above middle C, you will transpose the keyboard up a full octave. The
maximum range is up or down 12 semitones.
NOTE:
Middle C refers to the C key at the center of the Sub Phatty’s keyboard, not
to the pitch usually referred to as middle C, which is actually one octave higher.
PITCH BEND RANGE UP
The Sub Phatty’s pitch bend defaults to two semitones up or down, but you can
change either direction to any interval you want. To specify the
PITCH
wheel’s
range when you push it up, engage Shift mode and press the
BANK 1
and
PATCH
2
buttons. Pressing any key selects the bend interval, with each key increasing the
interval by a semitone as you go from left to right. If you want to bend up an octave,
for example, press the middle C key. The maximum range is 24 semitones up.
PITCH BEND RANGE DOWN
To specify the
PITCH
wheel’s range when you push it down, engage Shift mode
and press the
BANK 1
and
PATCH 3
buttons. Pressing any key selects the bend
interval, with each key increasing the interval by a semitone as you go from left
to right. If you want to bend down a perfect 5th, for example, press the low G key.
The maximum range is 24 semitones down.
