Moog MSD C2, Operation Manual

Page: 29 / 72

29
MSD Single-Axis Servo Drive Compact Operation Manual
ID no.: CA97555-001 Date: 04 /201 8
moog
Mains supply for C2 and C3 devices
NOTE
Before commissioning, the value of the connected mains voltage must be
set on the servo d
rive (factory setting = 3 x 230 V AC / 3 x 400 V AC).
+
X2
X3
L1
L2
L3 L1
L2
L3
K1 F1
Mains
3-phase
Mains
ÿlter Mains
choke
C2 and C3
Figure 4.16 Connection C2 and C3 mains supply 3 x 230 V (G394-030, G394-059) or 3 x 400 V
(G394-020, G394-035) depending on device design
+
X2
X3
L1
L2
L3 L1
N
K1 F1
Mains
1-phase
Mains
ÿlter Mains
choke
C2 and C3
Figure 4.17 Connection C2 and C3 mains supply 1 x 230 V) (G394-030, G394-059)
4.8.3 Connected load and mains fuse
Servo
Drive
Device rated power 1) [kVA]
Maximum cable cross-section
2)
of the terminal [mm²]
Specified mains
fuse, duty class
gG [A]
With mains
choke (4% u
K
)
Without
mains choke
Ferr. with
insul
3)
Ferr. w/o
insul
3)
G394-030 1.3 1.6
2.5 2.5
1 x 16 maximum
(1-phase)
3 x 16 maximum
(3-phase)
G394-020 1.5 1.9 3 x. 6 maximum
G394-059 2.6 3.2
2.5 2.5
1 x 16 maximum
(1-phase)
3 x 16 maximum
(3-phase)
G394-035 2.7 3.3 3 x 10 maximum
G394-080 3.5 4.3
4 4
1 x 20 maximum
(1 phase)
3 x 20 maximum
(3 phase)
G394-065 5.0 6.1 3 x 16 maximum
G394-120 8.1 10.5
4 6
3 x 32 maximum
G394-160 10.2 13.2 3 x 40 maximum
1) At 3 x 230 V AC or 3 x 400 V AC mains voltage and FT ≥ 8 kHz
2) The minimum cross-section of the mains power cable depends on the local regulations and conditions, as well as on the rated current of the s ervo d rive.
3) Ferr. with insul. = Ferrule with plastic insulation, Ferr. w/o insul. = Ferrule without plastic insulation
Table 4.6 Connected load and mains fuse