Moog MSD C2, Operation Manual

Page: 30 / 72

30
MSD Single-Axis Servo Drive Compact Operation Manual
ID no.: CA97555-001 Date: 04 /201 8
moog
Mains supply for C5 devices
NOTE:
Before commissioning, the value of the connected mains voltage must be
set on the servo d
rive (factory setting = 3 x 400 V AC).
X3
L1
L2
L3
L1
L2
L3
K1 F1
+ X2
Mains
3-phase
Mains
ÿlter Mains
choke
Figure 4.20 Connection of C5 to mains supply 3 x 400 V (G394-120, G394-160) depending on
device design
Mains supply for C4 devices
NOTE
Before commissioning, the value of the connected mains voltage must be
set on the servo d
rive (factory setting = 3 x 230 V AC / 3 x 400 V AC).
+
X2
X3
L1
L2
L3
L1
L2
L3
K1 F1
Mains
3-phase
Mains
ÿlter Mains
choke
C4
Figure 4.18 Connection of C4 to mains supply 3 x 230 V (G394-080) or 3 x 400 V (G394-065)
depending on device design
+
X2
X3
L1
L2
L3
L1
N
K1 F1
Mains
1-phase
Mains
ÿlter Mains
choke
C4
Figure 4.19 Connection of C4 to mains supply 1 x 230 V (G394-080)
CAUTION ! Shutdown of the pre-charging !
To protect the servo drive from thermal overload, make sure that the pre-charging of the DC
link is not switched on for more than
2 minutes
without the main contactor is active.
The pre-charging of the DC link is not designed for high power consumption during the
operation.
Ignoring of this rule may destroy the device !