Address SW1 SW2 SW3 SW4 SW5 SW6
Address SW1 SW2 SW3 SW4 SW5 SW6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Off On On On On On
On Off On On On On
Off Off On On On On
On On Off On On On
Off On Off On On On
On Off Off On On On
Off Off Off On On On
On On On Off On On
Off On On Off On On
On Off On Off On On
Off Off On Off On On
On On Off Off On On
Off On Off Off On On
On Off Off Off On On
Off Off Off Off On On
On On On On Off On
Off On On On Off On
On Off On On Off On
Off Off On On Off On
On On Off On Off On
Off On Off On Off On
On Off Off On Off On
Off Off Off On Off On
On On On Off Off On
Off On On Off Off On
On Off On Off Off On
Off Off On Off Off On
On On Off Off Off On
Off On Off Off Off On
On Off Off Off Off On
Off Off Off Off Off On
CHANGING SETTINGS FOR RECEIVER / DRIVER UNITS
DIPSWITCHES
The dipswitches serve a dual purpose. First, they control the address of the pan/tilt when operated via RS485. Second, they control the alarm and display
functions for the pan/tilt. Address changes are made using the dip switches located on the PC board.
Dipswitches
UNIT ADDRESSES FOR 485 CONTROL
The dipswitches come factory preset with switch 6 in the on position, indicating the address mode. The default address for the pan/tilt on receiver/driver versions of the DeputyDome™ is
preset at the factory as "1." If more than one unit is being used with 485 control it will be necessary to change the address for each additional unit.
To change the address, power down the unit, remove the pan/tilt from the housing, and set the address using the dipswitch settings shown in Chart 1 in the next column. Replace the
unit and power up.
CHART 1 - RECEIVER/DRIVER PAN/TILT ADDRESSES
19
20
21
22
23
24
25
26
27
28
29
30
31
21
22
